How to connect the conveyor belt using glue / adhesive material.
Here's how:
1. The first step is to cut the rubber belt. Cutting length size exceeds 35cm - 45cm for joints. The edges are slanted so that the gluing surface area becomes wider. The wider the gluing surface the better.
2. Peel the rubber belt for gluing. The peeled sides meet when connected.
3. The burrs use sandpaper grinding stones until the fiber belt layer is clean. Be careful not to tear the fabric fibers. Then clean the surface from grinding dust.
4. Gluing process. Prepare the glue and hardener. Pour in one container with the right amount. Stir well.
5. Pour and apply evenly the glue on the belt surface that has been cleaned. The coating process is carried out twice. The first layer must be completely dry. Wait for about an hour (ideally 10 hours) before the second coating. The second layer is the attachment layer. For the second layer, just wait for about 3-6 minutes or if the felt layer is not touched on the finger. Paste the two ends of the belt. For attaching both ends of the belt, the second layer of gluing should not be too dry because the belt does not want to stick. If it's already dry, coating can be done again. After sticking, the o'clock connection uses a hammer or press using a roll to make the connection really stick.
